Your Wave Spa's inflatable lid sits inside the cover and helps keep the heat in. It's inflated separately from the spa, using the inflation hose and the Bubble button on your controller.
Eco-Foam spas (Como, Garda, Tahoe) and the Adriatic
Lay the inflatable lid flat inside the cover, with the valve facing outwards.
Unscrew the cap underneath the heater (reached through the opening below the warning panel) and attach the inflation hose, screwing the end connector on until hand-tight.
Attach the other end of the hose to the valve on the inflatable lid.
Press the Bubble button on the controller to inflate the lid.
When it's inflated, press Bubble again to stop.
Disconnect the hose from the lid and the heater, then replace the cap underneath the heater.
Inflatable spas (Aegean, Atlantic, Pacific)
The Bubble/Inflate button is also used to inflate the inflatable lid, with the same inflation hose you used to inflate the spa. See the inflation steps in your instruction manual (PDF).
Tips
Don't leave it unattended while inflating, and stop as soon as the lid is firm.
Always replace the cap on the heater afterwards.
Keep the cover on whenever the spa isn't in use. It keeps the heat in and debris out.
The cover is not a safety cover. Children must be supervised around the spa at all times.
Need help?
Not sure which hose you need? See Which Inflation Hose Do I Need? Or use the chat widget at the bottom of the page and tell us your spa model.
Partager:
Antarctic Ice Bath: Seams, Leaks and Repairs